FREE Shipping at $100 *UPS Ground in the contiguous U.S.A.

Custom Color Punch Kit

Custom Color Punch Kit

SKU: -

SHARE:

Do you need one cap and not 1,000? The Custom Color Punch Kit is the tool for you. Take any standard edgebanding or veneer, apply SpeedTape, punch your cap out and you are done.

*For use with material up to .022". Not recommended for Plastic Laminate or 1mm thick edgebanding.

Custom Color Accessories & Replacements

Custom Color Punch Kit Overview
One-Off Fastcaps
With Wood Veneers
Installing the Ejector Pin
Terry's Review

  1. Best purchase in a while

    10/10, As a carpenter joiner, it's always been frustrating finding cover caps to match timber/ timber veneer This works perfectly. Couldn't rate it better!

  2. Tim J. Ziegler10/31/2012

    Awesome Products

    Hi Paul, I just wanted to share that I bought two more of your awesome products about a week ago through Westlund here in Minnesota. I bought your Macro trimmer and I also bought the Speed Roller Pro. These tools are awesome, I had been using a plain old side cutter before this and wow what a difference, plus it reaches across the edge banding. Very good tool and very solid, when you put this tool in your hand you know its going to work. Now the Speed Roller Pro, I have been using a J style Roller for a long time But when I seen this new little gadget (The Speed Roller Pro) I knew I had to try it. That is the slickest, fastest, easiest, and handiest Hand tool I have purchased in a long time. I use my tools for a living and when I started using that I could not believe the difference. You can actually control the Speed Roller Pro, where as the J Roller it controlled you. I also own your Custom color Punch kit, another awesome tool, very well built. I am a very firm believer of your tools Paul, keep up the great work. By the way those Blind Nails you sent me a while back I use them constantly in my finish room I will send you a picture some time. So keep up the awesome work, keep the new idea’s flowing. Sincerely, Tim J. Ziegler ZIEGLER WOODWORK & SPECIALTY

Add a Review

What's the thickest mm you can punch?

It is going to depend greatly on the material you are using. On a soft enough material, up to 1/16” is possible, but on some materials, the max may be as low as .02".